# GPIO

## Overview

The GPIO example shows how to change GPIO output pin level and use GPIO input pin trigger interrupt.

## Board Setting

No special settings are required

## Known Issue

When GPIO is used as the key input pin detection, the input level jitter will cause GPIO to detect the change of input level multiple times due to the mechanical jitter of the key.

## Running the example
- chips that support both-edge trigger mode, the project are configured in both-edge trigger mode,so every time a button is pressed and released, the LED state will be toggle, and the LED toggle logs will be printed twice.
- When the example runs successfully, the LED will flash 5 times, then press GPIO button (please check [Button](lab_board_resource) section of specific board) will toggle the LED status, and the following message is displayed in the terminal:
```console
toggling led 5 times in total
toggling led 1/5 times
toggling led 2/5 times
toggling led 3/5 times
toggling led 4/5 times
toggling led 5/5 times
input interrupt
user led will be switched on off based on user switch
toggle led pin output
toggle led pin output
```