# linv2_slave
## Overview

The linv2_slave sample project shows that LINV2 sends/receives data at slave mode.

## Board Setting

Requires a USB_LIN debugger
Please refer to [Pin Description](lab_board_resource) for specific board.
connect LIN signal on board to USB_LIN debugger.

## Running the example

configure usb_lin debugger:
- configure com and baudrate, then click `Set to Debugger` option
  ![lin_debugger_configuration](../../lin/doc/lin_debugger_configuration.png)
- Configure sent data, including master sent, master receive and sync break, the sync break could wake up slave from sleep mode：
  ![lin_debugger_master_sent](../../lin/slave/doc/lin_debugger_master_sent_config.png)
- Running the example, check the result in debugger window
  ![lin_debugger_master_result](../../lin/slave/doc/lin_debugger_master_result.png)

When the example runs successfully, the log would be seen on the terminal like:
```console
LIN slave example
LIN bus timeout, will enter sleep mode
LIN wakeup
ID: 31, receive 8 bytes
0 1 2 3 4 5 6 7
ID: 30, sent 8 bytes
7 6 5 4 3 2 1 0
```