12.2. JPEG encode

12.2.1. Overview

JPEG decoding example project demonstrates how to encode an image capture from camera sensor to a JPG file using either JPEG module or software jpeg library

12.2.2. Board Setting

  • Connect the USB disk to the development board usb0, or insert the SD memory card into the development board SD card

  • Connect LCD screen and Cam camera to development board

12.2.3. Engineering configuration

  • File CMakeLists.txt:

  • If set (JPEG_USE_SDCARD 1) is configured, jpeg files are stored in SD card or set (JPEG_USE_UDISK 1), they will be saved to udisk.

  • set (JPEG_HW_MODE 1) encodes through the JPEG hw module; set (JPEG_HW_MODE 0) encodes through the software library.

  • if use ov7725 camera device, configure set(CONFIG_CAMERA "ov7725") in CMakeList.txt

  • if use ov5640 camera device, configure set(CONFIG_CAMERA "ov5640") in CMakeList.txt

12.2.4. Store picture size

  • The image format stored in this routine is JPG, and the resolution size is 640*480

12.2.5. Running the example

  • Configure storage in CMakeLists.txt

  • Connect camera senor, LCD pannel and storage to board

  • Power on the board

  • Download built elf into development board and run the demo

  • If everything goes well:

    • camera sensor preview will be shown on LCD panel

    • press GPIO button (please check Button section of specific board) will save current frame and encode to jpeg file and save to target storage

    • encoded image will be decoded and shown on LCD pannel until GPIO button is pressed again. Once it’s been pressed, preview will be resumed.