31.2.6.3. Netx Duo Http Server

31.2.6.3.1. Overview

The netx duo http server example shows netx http server functions. This example enables a http server.

31.2.6.3.2. Board Setting

  • Connect an Ethernet port on PC to a RGMII port or a RMII port on the development board with an Ethernet cable

31.2.6.3.3. Project Configuration

  • Ethernet Port Settings: Refer to Ethernet common project settings

  • By set(CONFIG_ECLIPSE_THREADX_NETXDUO_ADDONS_DHCP 1) in CMakeLists.txt, the DHCP will be enabled

31.2.6.3.4. Running the example

When the example runs successfully, it will print phy link status periodically until its status becomes Up. Following message is displayed in the terminal: When accessing the HTTP server, a window will pop up asking for a username and password. The default username is “name” and the default password is “password”. After confirmation, the page will be displayed.

NetX HTTP Server unable to find file: /

NetXDuo is running
IP address: 192.168.1.223
Mask: 255.255.255.0
Enet phy init passed !
Link Status: Down
Link Status: Down
Link Status: Up
Link Speed:  1000Mbps
Link Duplex: Full duplex