32.2.5.7. Netx Duo Ping

32.2.5.7.1. Overview

The netx duo ping example shows netx arp and icmp functions. This example enables ping response function.

32.2.5.7.2. Board Setting

  • Connect an Ethernet port on PC to a RGMII port or a RMII port on the development board with an Ethernet cable

32.2.5.7.3. Project Configuration

  • Ethernet Port Settings: Refer to Ethernet common project settings

  • By set(CONFIG_ECLIPSE_THREADX_NETXDUO_ADDONS_DHCP 1) in CMakeLists.txt, the DHCP will be enabled

32.2.5.7.4. Running the example

When the example runs successfully, it will print phy link status periodically until its status becomes Up, and it will print ICMP packets received count periodically. Following message is displayed in the terminal:

NetXDuo is running
IP address: 192.168.1.223
Mask: 255.255.255.0
received 0 ICMP packets
Enet phy init passed !
received 0 ICMP packets
Link Status: Down
received 0 ICMP packets
received 0 ICMP packets
Link Status: Up
Link Speed:  1000Mbps
Link Duplex: Full duplex
received 0 ICMP packets
received 0 ICMP packets
received 0 ICMP packets
received 0 ICMP packets
received 0 ICMP packets
received 0 ICMP packets
received 1 ICMP packets
received 2 ICMP packets
received 3 ICMP packets
received 4 ICMP packets