46.3. HRPwm Output

46.3.1. Overiew

pwm project configures several different types of waveforms and outputs them.

Forced output
Fault mode
Edge-aligned
Center-aligned

46.3.2. Configurations

Dual Channel Oscilloscope
Install the serial terminal, view board information, and configure the serial terminal parameters
HRPWM_P0 and HRPWM_P2 pins Check the information according to the board model

46.3.3. Running the Demo

After power on, the oscilloscope can observe P0, P1 output high level, low level, edge-aligned PWM and center-aligned PWM
Compared with the reference PWM, the HRPWM output pulse width differs by HRPWM_SET_IN_PWM_CLK clock cycles
Serial port printing information:

hr pwm example


>> Test force HRPWM output on P0 and P2
Output high
Output low


>> Generate edge aligned waveform
Two waveforms will be generated, HRPWM P0 is the target waveform
whose duty cycle will be updated from 0 - 100 and back to 0; HRPWM P2 is a reference


>> Generate central aligned waveform
Two waveforms will be generated, HRPWM P0 is the target waveform
whose duty cycle will be updated from 0 - 100 and back to 0; HRPWM P2 is a reference
test done

Note

Output the PWM waveform once, and if you observe the waveform again, you need to run the program again.